No audit programs here. deleting this sequence of ebuilds. will replace with compat and broadcom in a few moments

1 files changed, 0 insertions, 147 deletions

diff --git a/net-wireless/compat-wireless/compat-wireless-2.6.35-r1.ebuild b/net-wireless/compat-wireless/compat-wireless-2.6.35-r1.ebuild
deleted file mode 100644
index 2c946dad..00000000
--- a/net-wireless/compat-wireless/compat-wireless-2.6.35-r1.ebuild
+++ /dev/null
@@ -1,147 +0,0 @@
-# Copyright 1999-2010 Gentoo Foundation
-# Distributed under the terms of the GNU General Public License v2
-# $Header: $
-
-EAPI="2"
-inherit linux-mod linux-info versionator eutils
-
-##Stable
-
-MY_P=${P/_rc/-rc}
-
-#remove the below line
-MY_P=${PF/-r/-}
-#remove the above line
-
-MY_PV=v$(get_version_component_range 1-3)
-DESCRIPTION="Stable kernel pre-release wifi subsystem backport"
-HOMEPAGE="http://wireless.kernel.org/en/users/Download/stable"
-SRC_URI="http://www.orbit-lab.org/kernel/${PN}-2.6-stable/${MY_PV}/${MY_P}.tar.bz2"
-
-LICENSE="GPL-2"
-SLOT="0"
-KEYWORDS="amd64 x86"
-IUSE="atheros_obey_crda debugfs debug-driver full-debug injection noleds tinyversionoverride"
-
-DEPEND=""
-RDEPEND="=sys-kernel/linux-firmware-99999999"
-
-S=${WORKDIR}/${MY_P}
-RESTRICT="strip"
-
-CONFIG_CHECK="!DYNAMIC_FTRACE"
-
-pkg_setup() {
-#	if ! version_is_at_least 4.4.3 "$(gcc-fullversion)"; then
-#		 die
-#	fi
-	linux-mod_pkg_setup
-	kernel_is -lt 2 6 27 && die "kernel 2.6.27 or higher is required for compat wireless to be installed"
-	kernel_is -gt $(get_version_component_range 1) $(get_version_component_range 2) $(get_version_component_range 3) && die "The version of compat-wireless you are trying to install contains older modules than your kernel. Failing before downgrading your system."
-	if kernel_is -eq $(get_version_component_range 1) $(get_version_component_range 2) $(get_version_component_range 3); then
-		if use tinyversionoverride; then
-			ewarn "You have the tinyversionoverride use flag set which means you know for a fact that your"
-			ewarn "kernel is older than the compat-wireless you are installing."
-			ewarn "Most likely you have no clue what you are doing and should hit control-C now"
-			ewarn "before you downgrade your system. Ten seconds to think about it."
-			epause 10
-		else
-			ewarn "Your kernel version is most likely newer than the compat-wireless release you are"
-			ewarn "trying to install. If you are certain that your kernel is older then you can set"
-			ewarn "the tinyversionoverride use flag to override this safety check."
-			epause 5
-			die "Your kernel version is too close to the compat-wireless version to risk installation."
-		fi
-	fi
-	linux_chkconfig_module MAC80211 || die "CONFIG_MAC80211 must be built as a _module_ !"
-	linux_chkconfig_module CFG80211 || die "CONFIG_CFG80211 must be built as a _module_ !"
-}
-
-src_prepare() {
-	#whynot patch is against the makefile to fix general brokeness
-	epatch "${FILESDIR}"/whynot-2.6.32.patch
-
-	#this patch fixes a trivial typo in the config.mk
-	epatch "${FILESDIR}"/fix-typos-2.6.35_rc2.patch
-
-	#this patch is needed to forcibly enable new ralink chips because the shipped config.mk doesn't enable them
-	epatch "${FILESDIR}"/force-enable-new-ralink.patch
-	epatch "${FILESDIR}"/force-enable-new-ralink-pci.patch
-
-	#this patch is needed for general craziness of WEXT being removed from the kernel
-	epatch "${FILESDIR}"/WEXT-EXT-nuts.patch
-
-	#test patch for fixing iwlagn issues
-	epatch "${FILESDIR}"/reinette-test2.patch
-
-	#this patch ignores the regulatory settings of an atheros card and uses what CRDA thinks is right
-	if use atheros_obey_crda; then
-		ewarn "You have enabled atheros_obey_crda which doesn't do what you think."
-		ewarn "This use flag will cause the eeprom of the card to be ignored and force"
-		ewarn "world roaming on the device until crda provides a valid regdomain."
-		ewarn "Short version, this is not a way to break the law, this will automatically"
-		ewarn "make your card less functional unless you set a proper regdomain with iw/crda."
-		ewarn "Pausing for 10 secs..."
-		epause 10
-		epatch "${FILESDIR}"/ath_ignore_eeprom.patch
-	fi
-
-	if use injection; then
-		epatch "${FILESDIR}"/400[24]_*.patch
-		epatch "${FILESDIR}"/mac80211.compat08082009.wl_frag+ack_v1.patch
-		epatch "${FILESDIR}"/4013-runtime-enable-disable-of-mac80211-packet-injection.patch
-		epatch "${FILESDIR}"/compat-chaos.patch
-		epatch "${FILESDIR}"/rtl8187-mac80211-injection-speed-2.6.30-rc3.patch
-#		epatch "${FILESDIR}"/super_secret_patch.diff
-	fi
-	use noleds && epatch "${FILESDIR}"/leds-disable-strict.patch
-	use debug-driver && epatch "${FILESDIR}"/driver-debug.patch
-	use debugfs && sed -i '/DEBUGFS/s/^# *//' "${S}"/config.mk
-	if use full-debug; then
-		if use debug-driver ; then
-			sed -i '/CONFIG=/s/^# *//' "${S}"/config.mk
-		else
-			ewarn "Enabling full-debug includes debug-driver."
-			sed -i '/DEBUG=/s/^# *//' "${S}"/config.mk
-		fi
-	fi
-}
-
-src_compile() {
-	addpredict "${KERNEL_DIR}"
-	set_arch_to_kernel
-	emake KVER="${KV_FULL}" || die "emake failed"
-}
-
-src_install() {
-	for file in $(find -name \*.ko); do
-		insinto "/lib/modules/${KV_FULL}/updates/$(dirname ${file})"
-		doins "${file}" || die "failed to install module ${file}"
-	done
-	dosbin scripts/athenable scripts/b43load scripts/iwl-enable \
-		scripts/madwifi-unload scripts/athload scripts/iwl-load \
-		scripts/b43enable scripts/load.sh \
-		scripts/unload.sh || die "script installation failed"
-
-	dodir /usr/lib/compat-wireless
-	exeinto /usr/lib/compat-wireless
-	doexe scripts/modlib.sh || die
-
-	dodoc README || die
-	dodir /$(get_libdir)/udev/rules.d/
-	insinto /$(get_libdir)/udev/rules.d/
-	doins udev/50-compat_firmware.rules
-	exeinto /$(get_libdir)/udev/
-	doexe udev/compat_firmware.sh 
-}
-
-pkg_postinst() {
-	update_depmod
-	update_moduledb
-	einfo 'You may have problem if you do not run "depmod -ae" after this installation'
-	einfo 'To switch to the new drivers without reboot run unload.sh then load.sh'
-}
-
-pkg_postrm() {
-	remove_moduledb
-}